|
|
#1 (permalink) |
|
Junior Member
Join Date: Apr 2008
Location: Castro Valley, CA Bay Area
Bike: 07 FZ6 Red
Posts: 371
|
What size bolt is used in pickup rotor cover?
Found today that one of my seven pickup rotor cover bolts is missing (see attached pic, Item #2 for what this is on the right hand side). From other threads, bolts falling out doesn't seem such an uncommon event. Trying to figure out the length of this bolt (manual says it is an M6 thread). I'm sure I could get one at the hardware store for about 10th the cost of getting it from the Yammie dealer. I could probably buy every single length available in M6 from the HW store at less cost than getting one from the dealer. Also, I suppose I could remove a second of the seven bolts and measure it, but I'd rather not mess with anything that is properly installed already. Thanks!
|
|
|
|
![]() |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Helped pickup another rider's bike the other night | boo68 | FZ6 General Discussion | 22 | 07-28-2008 02:42 PM |
| anyone drive a ford f150 pickup? | lonesoldier84 | The Bar | 15 | 07-10-2008 09:06 PM |
| Disc Rotor Removal | mglowe | Garage / Mechanical Help | 3 | 06-22-2008 10:45 AM |
| Brake rotor compatibility? | elwood206 | FZ6 StreetFighter | 6 | 05-14-2008 03:52 PM |
| oil drain bolt | Redhawk | FZ6 General Discussion | 17 | 08-19-2007 04:42 PM |