Throttle Body Synchronization

[mellofelow]

So is this a done deal?

I have experience with GB's for cars. Although I don't handle payments either but basically I am the administrator or order taker if you will. Once all the payment information has been collected for 10 buyers (CC#, address... etc), I then turn it over to the vendor. So in a sense it's one big multi payment.

Anyone up for this? Do you think Morgan will accept this GB?

[bd43]

I suppose it's worth entertaining, but I couldn't wait. After Scorphonic's efforts, I saw no resolution so I order today from Morgan. 5-7 £, maybe $15 savings in a GB, you gotta just bite the bullet and get on with it. Just means I have to use it 1.2 times instead of once to get my money's worth instead of taking it to the shop for them to do it.

Thanks for all your efforts Scorphonic!

[Scorphonic]

Your very welcome Biker dude. If I wasn't a student with a capped credit card limit (which is quite low...thankfully!!) then i would have been able to do the group buy through my card...but like I said, two weeks time I'm putting a ring on a finger...so the credit card is pretty much full!!!

[D-Mac]

I just placed an order for one (Morgan Carbtune). Looks like a great product. I'm almost to 4000 miles and there's no sense in waiting anymore. Might as well do this before winter. No way the dealer is touching my bike.

I'll post an update when it's done.

Cheers, D-Mac

[D-Mac]

Got my Morgan Carbtune Pro about a week ago (fast delivery - about one week from the U.K. to Michigan) and I finally got a chance to try it out today.

It took me a bit longer than planned because I had inadvertently buried the four TB lines on the bike down under the air box when I took off the box off last month. That meant I had to take off the air box again to retrieve the TB lines (otherwise you don't have to remove the airbox at all).

It all hooked up easily. It comes with a 4" restrictor tube that you just cut into four pieces to make the four restrictors - one for each line. One end of each restrictor tube inserts tightly into each tube already on the bike and the other inserts inside each rubber tube that runs to the carbtuner. Turn on the bike, warm it up, and turn screws 2,3,4 to sync to TB#1. It would be very hard to screw this up.

My bike has 3900 miles on it. Turns out it was almost perfectly sync'd already! I adjusted the TBs a tiny, tiny bit (mostly #4) to lock it down and that was it. 5 minutes of adjustment and done. Next time all I have to do is lift the fuel tank, plug in the restrictors and turn on the bike. Couldn't be easier.

[bd43]

I got my Morgan Carbtune about a week ago as well but didn't have time to play with it until today as the weather here really sucked the last couple of days and I wanted to take the bike for a spin to get the engine up to temperature before doing the sync test.

Here is the as-found at idle which is roughly 1300rpm...



It didn't look that bad for 11600km on the bike.

Here is the as-found at 4000rpm...



For the amount that they were off at both rpm's I decided to leave it, no adjustment necessary.

The manual states intake vacuum at 21.8 cmHg, and the difference in any two throttle bodies should not exceed 1 cmHg. I like that this tuner comes with cmHg markings.

P.S. Sean from Morgan was top notch to deal with and prompt in all the inquiries I made. Even though they don't advertise payment via Paypal, they take it if you ask. Mailing was prompt and the delivery time reasonable just outside of a week. Sean was answering emails on the weekend and Sunday's . Easy assembly, comes in a nice case, and the Carbtune worked great. I highly recommend it.

[Scorphonic]

Thanks for the update there bikerdude.

I ordered mine yesterday and got it today...needless to say they only had to post it 2 minutes down the road!

Surprisingly, I ordered only the 4 unit carbtune with NO tool pouch...when i opened my parcel there was my kit all nicely wrapped up in the tool pouch!!

I guess Sean Morgan is an even more top notch guy who obviously likes the fact that I advertised his product even further in about 6 countries!! They just threw in the pouch for free!!!!

Thats what I believe anyways, either that or they sent it by accident which I would strongly doubt since it clearly states on my invoice that I spent only 55 quid on it.

Thank you Sean!!! I'll certainly keep advertising this product!

[mellofelow]

For those interested in Morgan, the current exchange rate it comes to $103.20 (if I calculated correctly). Heck, that's cheaper than the group buy price a month ago....

I better jump on this.

[mstewar1]

I used my morgan carbtune for the first time a few weeks ago. Worked like a charm, so easy. I like that it came with the fittings to fit our bike, whereas I seem to recall that the motionpro unit required an extra purchase to get the right fittings.

FWIW, My bike wasn't very far out of tune, I think I needed just a slight adjustment on #3 and that was it.

[Scorphonic]

Thats exactly what mine was like. After 16,000 miles I only had to do a very slight change to #3 and #4. 1 and 2 were perfect.

Its a good system...so so easy to use.