Scorpio Alarm Installation - Yamaha FZ6 Forums - International FZ6 Motorcycle Community Forum

cancervero · 10-16-2007, 12:42 PM

Hello everybody, I bought a Scorpio Alarm and did part of the installation.
I was wondering if someone has already completed this because I can figure out what to do about grounding the alarm to the bike and hooking it up to the rear signals.
Thanks

mikebike · 10-16-2007, 01:54 PM

gainesville ....WHere GA / FL ...other

Grecu · 08-13-2008, 09:04 PM

Hi,

Got the same alarm except my MCM module is defective. I would plug both grey wires to the flashers, the orange to the tail light and when ignition was turned on, my left flashers would stay on. I finally discovered theres a short in the module. In any case, im not sure what you are trying to say...

10-16-2007, 12:42 PM	#1
cancervero Junior Member Bike: FZ6 2006 Join Date: Oct 2007 Location: Gainesville Posts: 2 Thanks: 0 Thanked 0 Times in 0 Posts Rep Power: 0 Feedback Score: 0 reviews	Scorpio Alarm Installation Hello everybody, I bought a Scorpio Alarm and did part of the installation. I was wondering if someone has already completed this because I can figure out what to do about grounding the alarm to the bike and hooking it up to the rear signals. Thanks

10-16-2007, 01:54 PM	#2
mikebike just a rider Bike: FZ6 -- Blue Join Date: Jul 2007 Location: North Central Florida Posts: 1,342 Thanks: 75 Thanked 117 Times in 53 Posts Rep Power: 24 Feedback Score: 0 reviews	gainesville ....WHere GA / FL ...other __________________ mike http://www.crazyguyonabike.com/doc/tourdemiller3

08-13-2008, 09:04 PM	#3
Grecu Junior Member Bike: FZ6 2005 Join Date: Jul 2008 Location: Canada Posts: 4 Thanks: 0 Thanked 0 Times in 0 Posts Rep Power: 0 Feedback Score: 0 reviews	Re: Scorpio Alarm Installation Hi, Got the same alarm except my MCM module is defective. I would plug both grey wires to the flashers, the orange to the tail light and when ignition was turned on, my left flashers would stay on. I finally discovered theres a short in the module. In any case, im not sure what you are trying to say...

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)