Shad 50 Top Case and Rack Installation

[FZSex]

nah twisted throttle are cool folks, I returned the top case and rack for a refund. Exchanged for some risers which I wanted anyway to keep away from the 15% restocking fee, good folks there

[FZSex]

I just ordered my shad top case and top master kit from adventuremotousa.

I went with the SH37 (wanted extra capacity but not EXTRA capacity lol).

Question, with this set up, has anyone tried using the sw-motech removable side supports for the PLX cases or the givi hardware? I'm guessing it may not be possible. Would be a good option though to be able to add the side cases down the road (come on spring, I'm ready for camping)

Found this online, this is what it will look like

[bcityroller]

I'm not seeing your image so hopefully not reposting something.

In any event Shad does have a side case rack that mates with their top case rack - it bolts into a couple of empty threaded holes in the top rack, to the rear peg brackets, and then over the licence plate light to itself. Not sure whether this would limit you to Shad cases or not.

Rack is Y0FZ64SF. Attached fitting guide shows how it mounts.

[FZSex]

ahhh bet its cause you have to be logged into that forum for the pic to show.

Just uploaded it to picasa to share (if you still dont see it oh well!) haha

Oh thanks for the pdf above - ouch, looks like an ugly setup especially if you already have the tail cleaned up with a FE oh well.