Jman

I did not use that piece. The only thing I can think of (that it may be for) - is to create some back pressure if you remove the DB killers, but that is a guess, at best.

the circle with the holes was in the first pic when you had everything on the table. its to the left of the cat elm. right between the cat elm and coat hanger

http://www.fz6-forum.com/forum/attac...install-p1.jpg

Lucky, there is also a coat hanger looking piece that is used to install the springs to make it easier on your fingers.

The piece between the cans, I just carefully moved in between them. You could put a few layers of masking tape on the can surfaces while u r installing. I don't like the gap in the tail light and the plastic piece(stock set up does this too), so I bent the hanging piece between the cans to raise it up a little. The mid-pipe and two cans you will need to jockey around a little bit to get perfect alignment. The circle with the three holes I don't think it was used. If u send a picture it may jog the memory.

i had a couple of Q's about the leo install. first; that pice that gose between the two cans, dosent fit good did you grind it down or what did you do to make it fit without if sracthing your cans? 2. what is that pice for that is a metal circle and has a couple of holes in it? 3. what part do you have to aline up? you said it was kinda tricky.

611.15 in August of this year, but they have raised their price since then. Link FZ6 S2 600 FAZER (07-08)

if you dont mind how much did you pay for the leos?

You're welcome.

Thanks for the rep!

On my 2002 Yamaha YZF600R. It was a stainless can. I thought it sounded good. My friend had the same exact bike but got the Carbon fiber Scorpion can. For some reason, it seemed like his sounded a little throatier. That is one of the reasons I got the CF for the FZ6.